[hackerspaces] [ SPAM 4.8 ] Re: Laser Cutter Fires?

[bownes]

At the TVGoG, we've never had a fire leave the enclosure, but it was close. A member left the cutter unattended while doing a raster engraving, a belt broke, and the laser was firing constantly at a single spot on a piece of flammable material, which caught fire, setting anything flammable inside the enclosure on fire. Including the viewport filter, constructed of acrylic. It was caught before the acrylic was breached. Total damage about $150 in parts and some wounded ego. 

Remediation included posting a warning never to leave the laser cutter unattended, beefing up the warning, and adding the melted plastic viewport to the Wall of Shame. Ok, maybe not the last part. 

iii

> On Apr 29, 2015, at 14:10, Pete Prodoehl <raster at gmail.com> wrote:
> 
> 
> At Milwaukee Makerspace we have air lines running through the building, and use air assist with our laser cutters, which can help avoid fires. I don't believe we've ever had a fire besides material burning a little too much when cutting. During training people are shown how to turn on the exhaust and the air assist, and as long as those things are done, and you don't do anything too stupid (and don't leave it unattended!) all has been good.
> 
> 
> Pete
> 
> 
>> On 4/29/15 1:06 PM, Joshua Pritt wrote:
>> No fires yet.  But one of the main safety rules with the laser is to never leave it unattended.  You should be able to hit the emergency stop button the moment you see a flame then extinguish it immediately.  Also make sure there is a fire extinguisher right next to the laser just in case.
>> 
>> 
>> 
>> On Wed, Apr 29, 2015 at 1:56 PM, Robert Davidson <robert at dallasmakerspace.org <mailto:robert at dallasmakerspace.org>> wrote:
>> 
>>    I wanted to know how many out there have had a fire on there CO2
>>    Laser?
>> 
>>    What was the root cause?
>> 
>>    I define fire as leaving the confines of the machine.
>>    Though if your machine was destroyed by a fire in the tray that
>>    would count as well.
>> 
>> 
>>    I can start out with Dallas Makerspace we had the High Voltage
>>    line arc to the metal case and caused a fire in the laser tube
>>    area. (It was quickly extinguished with a Fire Extinguisher)
>> 
>>    Artifacture a local company in Dallas; there CO2 laser destroyed a
>>    large part of there building from a fire that was not observed.     Root Cause: (Guessing as it was absolute destruction was that the
>>    material was left in the tray from acrylic that had fallen through
>>    the tray)
>> 
>> 
>>    Robert Davidson
>>    Dallas Makerspace
> 
> _______________________________________________
> Discuss mailing list
> Discuss at lists.hackerspaces.org
> http://lists.hackerspaces.org/mailman/listinfo/discuss