[sudoroom] [Noisebridge-discuss] Fwd: High torque servos?

[Gopiballava Flaherty]

You need a voltage regulator. A linear one is simpler and cheaper but gets hotter when you draw more power. It also has a minimum voltage drop. So if you want 5v out, you need more than 5v in. Some are better than others. Low dropout ones can be used at only a small voltage above your desired voltage. They are inefficient. If you give a 5v one 10v in, it burns half the power as heat. 

Switched mode are complex and fancy and efficient. Some can raise or lower the voltage. They have a spec for input voltage range and maximum current. 

Also: check any wall wart power supplies with a voltmeter and make sure they do what they say. Some of them are not regulated. Most nowadays are but you can't be certain. Some put out quite high voltages until you draw power then they drop a lot. Some devices are built to tolerate wide input ranges and some will not tolerate even small variations without emitting magic smoke or failing to work right. 

Thanks,

gopi at iPhone


On Sep 8, 2012, at 17:44, Tracy Jacobs <kinetical at comcast.net> wrote:

> Thanks. I actually had it on a separate 6 v supply, but the first servo did not run and then smoked!  Not sure why still?  But good news is I tried a second one and it works!  Maybe it was a bad servo or I had a short somewhere, I don't know.
> 
> Thanks for your responses.
> 
> Tracy
> 
> 
> Begin forwarded message:
> 
>> From: Tracy Jacobs <kinetical at comcast.net>
>> Date: September 8, 2012 4:15:44 PM PDT
>> To: noisebridge-discuss at lists.noisebridge.net
>> Cc: Sudoroom list <sudoroom at lists.hackerspaces.org>
>> Subject: [sudoroom] High torque servos?
>> 
>> 
>> 
>>> 
>>> Has anyone used servos from Phidgets before? I ordered some high 
>>> torque servos from them:
>>> http://www.phidgets.com/products.php?product_id=3212_0
>>> 
>>> but they don't seem to be compatible with my Arduino. Can anyone 
>>> tell me what else I would need to make these servos work or suggest 
>>> another high torque continuous rotation servo that would be compatible 
>>> with the Arduino and the Arduino servo shield I already have? Thanks 
>>> for your advice,
>>> 
>>> Tracy
>>> __._,_.___
>>> Reply to sender | Reply to group | Reply via web post | Start a New Topic
>>> Messages in this topic (1)
>>> RECENT ACTIVITY: New Members 2
>>> Visit Your Group
>>> Switch to: Text-Only, Daily Digest • Unsubscribe • Terms of Use
>>> .
>>>  
>>> __,_._,___
>> 
>> _______________________________________________
>> sudoroom mailing list
>> sudoroom at lists.hackerspaces.org
>> http://lists.hackerspaces.org/mailman/listinfo/sudoroom
> 
> _______________________________________________
> Noisebridge-discuss mailing list
> Noisebridge-discuss at lists.noisebridge.net
> https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hackerspaces.org/pipermail/sudoroom/attachments/20120908/bc0e0d7e/attachment.html>